Polycentric hinge with flexion and extension pin-stops for controlled range of motion.
Lightweight, open patella design.
Increases stability and provides support and protection.
How To Wear:
Please follow the doctor's instruction. The following is the step of setting the angle. Open cap cover. Release pins, select correct settings and reinsert pins. To lock uprights in fixed 0 degree angle, set four pins setting at 0 degree. To lock in 10, 30, 50, 70, 90, and 110 degree of extension or flexion, set the two extension-pins on each hinge at desired setting in the location marked "lock" and the two flexion-pins in corresponding (same number) setting in the open opposing position. Repeat the procedure on the opposite side of knee support to match the new settings.
Insert foot into knee stabilizer and pull up to the knee.
Be sure the opening is on kneecap and hinge axis align with the knee joint.
Secure the upper two small hook and loop straps.
Thread through buckles and secure the upper and lower hook and loop straps to desired compression.
Application:
Post surgical use
Patellar subluxation/tilting
Collateral ligament injury
Cruciate ligament sprain
Moderate sprain/ strain
Size Chart
Measure around the mid-section of the knee, while in a standing position.
